Chevrolet Trax Owner's Manual page 92

90 Instruments and controls
Stop the vehicle in safe place, check
tyres and inflate the tyres to the
recommended pressure on the tyre
inflation pressure label.
When the system detects a
malfunction, the light blinks for about
one minute and then stays on for the
remainder of the ignition cycle.
The malfunction light comes on until
the problem is corrected. Have the
vehicle checked by a repairer.
See Tyre Pressure Monitor
Operation on page 267.
Pre-Heating System and
Diesel Particle Filter Light
(Diesel only)
Preheating indicator light
K illuminates yellow.
Illuminate when preheating is
activated. When the light goes out
the engine can be started.
Diesel particle filter indicator
light
L flashes yellow.
Flashes if the diesel particle filter
requires cleaning and previous
driving conditions did not permit
automatic cleaning. Continue driving
and if possible do not allow engine
speed to drop below 2000 rpm.
It goes off as soon as the self
cleaning operation is complete.
See Diesel particle filter on page
202.
Engine coolant temperature
warning light
C illuminates red.
This lamp tells you that the engine
coolant has overheated.
If you have been operating your
vehicle under normal driving
conditions, you should pull off the
road, stop your vehicle and let the
engine idle for a few minutes.
If the lamp does not go out, you
should switch the engine off and
consult a repairer as soon as
possible. We recommend that you
consult your authorised repairer.