Adjusting The Surround Sound; To Simulate The Surround Sound - 3D Phonic - JVC XV-K503TN Instructions Manual

XV-K505GD/XV-K503TN
LET0143-001A
[3U, 4U, US, UB, UT] (EN)

Adjusting the surround sound

To erase the 3D PHONIC
screen, press . The 3D
ENTER
PHONIC screen disappears if
there are no operations for
more than 10 seconds.
You can select the simulated surround effect depending on the disc contents. If
you connect the unit to your stereo system, you can enhance sound quality and
produce a greater surround effect.
To simulate the surround sound [3D PHONIC]
7
During playback
1
Press .
3D PHONIC
2
Within 10 seconds, select
the desired effect mode by
pressing .
3D PHONIC
Each time you press
3D PHONIC
effect mode changes as follows:
ACTION*
DRAMA
THEATER
OFF
* When you play the DVD disc recorded in Dolby Digital and contains more
than 3 channel sound, ACTION does not appears.
3
Press to adjust the
effect level.
You can adjust the effect level in
5 steps.
Toward L : Reduce the effect
Toward H : Enhance the effect
NOTES
¶
The sound effect (3D PHONIC) is possible only on discs which are recorded
in DOLBY SURROUND or DOLBY DIGITAL. However, some DOLBY
SURROUND or DOLBY DIGITAL discs do not contain the rear sound signal,
in this case, the setting can be changed but the sound effect cannot be
obtained.
¶
You can change the setting of the discs which do not contain the rear sound
signal, but the sound effect cannot be obtained.
¶
The sound effect is not possible, and will not work even if set when the unit
outputs the DTS or Dolby Digital bitstream signal from the DIGITAL OUT
jack.
¶
The sound effect will not be set or operate, even if
sound of DVD discs recorded in Linear PCM.
¶
When you set the 3D PHONIC function to on, the DOWN MIX and
COMPRESSION setting in the PREFERENCE 2 display are disabled.
Basic Operations
, the
Selected effect mode
3D PHONIC
English English
Español
Portugés
Chinese
3D PHONIC
THEATER
L H
3D PHONIC
THEATER
L H
Effect level
is pressed, on the
29