To Install Batteries In The Remote Control Unit - JVC XV-K503TN Instructions Manual

XV-K505GD/XV-K503TN
LET0143-001A
[3U, 4U, US, UB, UT] (EN)
Getting started
20

To install batteries in the remote control unit

The battery compartment is located on the back of the remote control unit.
1
Press down on the point shown by the arrow at the top of the compartment
cover, and pull up the cover to open the compartment.
2
Place the two accessory R6P (SUM-3)/AA(15F) batteries in the remote control
according to the polarity markings ("+" and "–") inside the compartment and
on the batteries.
3
Place the cover over the compartment, and press down lightly.
• The batteries will last about six months with normal use. If the functions of the
remote control become erratic, replace the batteries. See "Precautions for the
safe use of batteries" below for more information.
Precautions for the safe use of batteries
Observe the following precautions for the safe use of batteries. If they are used
improperly, their life will be shortened, they may burst or their contents may leak.
Precaution
¶
Remove the batteries from the remote control if it is not going to be used
for a long period of time.
¶
Remove dead batteries and dispose of them properly.
¶
Never leave dead batteries lying around, take them apart, mix them with
other refuse, or throw them into an incinerator.
¶
Never touch liquid that has leaked out of a battery.
¶
Do not mix new and old batteries, or batteries of different types, when
replacing them.