Automatic Mode; Setting Temperature - Skoda 2009 Yeti Owner's Manual

A
Switching cooling on and off
13
A
Setting of the temperature for the right side, operation of the seat heating of
14
the right front seat*
Note
Below the top row of buttons is located the interior temperature sensor. Do not
glue or cover over the sensor, otherwise it could have an unfavourable effect on the
Climatronic.

Automatic mode

The automatic mode is used in order to maintain a constant temper-
ature and to demist the windows in the interior of the car.
Switching automatic mode on
– Set a temperature between +18 °C and +26 °C.
– Move the air outlet vents 3 and 4
flow is directed slightly upwards.
– Press the button
AUTO
lights up, depending on which unit was last selected.
If the warning light in the top right corner of the button
Climatronic operates in "HIGH" mode. The "HIGH" mode is the standard setting of
the Climatronic.
When pressing again the button
mode and the warning light in the top left corner lights up. The Climatronic uses
only in this mode the lower blower speed. However taking into account the noise
level, this is more comfortable, yet be aware that the effectiveness of the air condi-
tioning system is reduced particularly if the vehicle is fully occupied.
By pressing again the button
The automatic mode is switched off by pressing the button for the air distribution
or increasing or decreasing the blower speed. The temperature is nevertheless
regulated.
Using the system Safety
AC
⇒ page 106, fig.
135, so that the air
. In the right or left top corner a warning light
lights up, the
AUTO
, the Climatronic changes into the "LOW"
AUTO
, you change into the "HIGH" mode.
AUTO
Driving Tips
switching cooling on and off
switching cooling on and off
⇒ page 114, fig.
– Press the button AC
in the button.
– When you again press the switch
off. The warning light in the button goes out. Only the function of the
ventilation remains active when no lower temperature than the
outside temperature can be reached.

Setting temperature

You can separate the interior temperature for the left and right side sepa-
rately.
– You can set the temperature for both sides after switching on the igni-
A
tion with the control dial
– If you wish to set the temperature for the right side, turn the control
A
dial . The warning light in the button
14
that differing temperatures for the left and right side can be set.
If the warning light in the button
cannot be set with the control dial
the button . The warning light in the button which indicates the possibility to
DUAL
set differing temperatures for the left and right side, goes out.
You can set the interior temperature between +18°C and +26°C. The interior
temperature is regulated automatically within this range. If you chose a tempera-
ture lower than +18°C, a blue symbol lights up at the start of the numerical scale. If
you chose a temperature higher than +26°C, a red symbol lights up at the end of
the numerical scale. In both limit positions the Climatronic operates at maximum
cooling or heating capacity, respectively. The temperature is not controlled in this
case.
General Maintenance Breakdown assistance
Heating and air conditioning system
139. The warning light lights up
, the cooling system is switched
AC
.
7
lights up, this indicates
DUAL
DUAL lights up, the temperature for both sides
A
. You can reinitiate this function by pressing
7
Technical Data
115