Information Display - Skoda 2009 Yeti Owner's Manual

26 Instruments and Indicator/Warning Lights
Warning against excessive speeds
This function enables you to set a speed limit, e.g. if you drive in town. A text in the
display is intended to draw your attention to the fact that you have exceeded the set
speed limit.
You can set the desired speed limit as follows:
•
Select the menu point Speed warning --- km/h (warning at --- km/h)..
•
Drive e.°g at a speed of 50 km/h.
•
A
Press the button on the windshield wiper lever
B
A
on the multifunction steering wheel*
D
50 km/h (warning at 50 km/h) is displayed in the information display*
⇒ page 25, fig.
25. You can increase or reduce this value with the button
windshield wiper lever or by turning the handwheel
steering wheel*.
•
The value is stored by repeated pressing of the button
A
wiper lever or the handwheel
D
If you now exceed the set speed limit, Speed 50 km/h exceeded will be shown in
the display. This message is indicated for as long as the speed is reduced below the
set limit or switch off the message by pressing the button
⇒ fig. 26
wiper lever or the handwheel
⇒ page 23, fig.
23.
An audible signal sounds as an additional warning signal.
The set speed limit remains stored even after switching off the ignition.
Fig. 26 Multi-functional
indicator: Control elements
⇒ fig. 26
or the handwheel
⇒ page 23, fig.
23. Speed warning
A
on the multifunction
D
A
on the windshield
B
on the multifunction steering wheel*.
A
on the windshield
B
A
on the multifunction steering wheel*
D

Information display*

Introduction
The information display provides you with information in a convenient way
concerning the current operating state of your vehicle. The information display
also provides you with data (depending on the equipment installed in the vehicle)
relating to the radio, multi-functional indicator, mobile phone and navigation
system.
Certain functions and operating conditions are always being checked on the
vehicle when the ignition is switched on and also while driving.
A
on the
A
Functional faults, if required repair work and other information are indicated by red
symbols ⇒ page 29 and yellow symbols ⇒ page 29.
Lighting up of certain symbols is combined with an acoustic warning signal.
Information and texts giving warnings are also shown in the display ⇒ page 32.
The display of text is possible in the following languages:
Czech, English, German, French, Italian, Spanish, Portuguese, Russian and
Chinese.
You can select the desired language in the setting menu.
The following information can be shown in the display (depending on the equip-
ment installed on the vehicle):
Fig. 27 Instrument cluster:
Information display