Install Checklist - Quadra-Fire MTV-E2-CSB Installation Manual

MT VERNON E2
E. Install Checklist
This standard work checklist is to be used by the installer in conjunction with, not instead of, the instructions contained in this installation manual.
Customer:
Date Installed:
Lot/Address:
Location of Fireplace:
Installer:
Dealer/ Distributor Phone #:
Serial #:
Model (circle one):
MTV-E2-MBK
WARNING! Risk of Fire or Explosion! Failure to install fi replace according to these instructions can lead to a fi re or explosion.
Appliance Install
Required non-combustible fl oor protection (Pg. 9)
Verifi ed clearance to combustible (Pg. 8)
Unit is leveled and secured (Pg. 18)
Venting/Chimney Section 4 (Pg. 12)
Venting confi guration complies with diagrams
Venting installed, sealed and secured in place with proper clearance
Exterior wall/roof fl ashing installed and sealed
Terminations installed and sealed
OAK installed and sealed (if needed) (Pg. 16 & 17)
Electrical
120VAC unswitched power provided to the appliance (Pg. 21)
Appliance Setup Section 5 (Pg. 17)
All packaging and protective materials removed
Accessories installed properly
Started appliance and verifi ed that all motors and blowers operate as the should
Manual bag and all of its contents are removed from inside/under the fi replace
and given to the party responsible for use and operation.
Hearth & Home Technologies recommends the following:
• Photographing the installation and copying this checklist for your fi le.
• That this checklist remain visible at all times on the fi replace until the installation is complete.
Comments: Further description of the issues, who is responsible (Installer/Builder/Other Trades, etc.) and corrective action needed:
Comments communicated to party responsible
6
ATTENTION INSTALLER:
Follow this Standard Work Checklist
MTV-E2-CSB MTV-E2-PFT
(Builder/Gen. Contractor)
7080-131D
MTV-E2-PDB MTV-E2-PBK
YES IF NO, WHY?
by
(Installer)
Part # 4017-254 • Rev B • 01/29/13
MTV-E2-PMH
on
(Date)
October 28, 2014