Pride Mobility Jazzy 1121 Owner's Manual page 27

the VSI is turned on and also gives the battery status, the VSI status, and the
electrical system status.
n Red, yellow, and green lights lit: Battery charged; VSI and
electrical system OK.
n Red and yellow lights lit: Charge battery if possible; VSI
and electrical system OK.
n Red lights only lit or slow flash: Charge battery as soon as
possible; VSI and electrical system OK.
n Rapid flash of lights: Indicates a fault in the VSI or the
electrical system. Refer to "VSI Error Codes."
n Ripple up and down of lights: The joystick was not in the
neutral position when the controller was turned on. If you get "ripple up and
down of lights", turn off the controller, allow the joystick to return to the
neutral position, then turn on the controller.
NOTE: If you still get "ripple up and down of lights", contact your
authorized Pride provider.
NOTE: When the batteries approach a discharged state, the first
red light will begin to slowly flash, reminding you the batteries need
to be charged immediately!
Speed/Profile Keys
There are two keys that control either the speed or the profile. See figure 17. This depends on how your VSI was programmed. Press
the speed/profile increase key to increase the speed or change the profile. Press the speed/profile decrease key to decrease the speed
or change the profile. The speed/profile setting is displayed on the maximum speed/profile indicator. If your power chair was
programmed with a drive profile, contact your authorized Pride provider for more information.
NOTE: We recommend that the first few times you operate your power chair, you set the speed to the slowest
setting until you become familiar with your new power chair.
Actuator Key and Actuator Lights (for optional equipment)
Actuator keys and actuator lights are used for optional equipment such as power elevating seats or power elevating leg rests. For specific
operation of the actuator keys and actuator lights, contact your authorized Pride provider. See figure 17.
Horn Key
The horn key activates the horn. See figure 17.
Off-board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the front of the VSI. See
figure 16. If you use an off-board charger, the charger current should not exceed 12 amps. Contact your authorized Pride provider for
more information.
CAUTION! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/
programming socket. See your authorized Pride provider for more information.
JAZZY 1121/REV C/SEPTEMBER 2002
V I I . O P E R A T I O N
Figure 17. VSI Controller Keypad
WWW.PRIDEMOBILITY.COM 27