Pride Mobility Jazzy 1121 Owner's Manual page 19

V . C O M F O R T
I V . C O M F O R T
Armrest Width Adjustment
You can change each armrest's width independently of each other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the armrest receiver bracket. See figure 9.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Loosen the jam nuts. See figure 9.
3. Loosen the adjusting screw.
4. Turn the adjusting screw clockwise to raise the front of the armrest, or turn the adjusting screw anticlockwise to lower the
front of the armrest. See figure 8.
5. Tighten the jam nuts to lock the adjusting screw into place.
Footrest Height
The footrest height is easily adjusted to one of six different heights in 1-in. increments.
To raise or lower the footrest:
1. Remove the nuts and bolts from bracket. See figure 10.
2. Raise or lower the footrest to the desired height.
3. Reinstall the bolts and nuts into the footrest bracket and tighten.
Footrest Depth
To adjust the footrest depth:
1. Remove the nuts and bolts from the bracket. See figure 10.
2. Move the footrest in or out to the desired depth.
3. Reinstall the nuts and bolts into the bracket and tighten.
Footrest Angle
You can adjust the angle of the footrest with a hex key. See figure 11.
To adjust the footrest angle:
1. Turn the setscrew clockwise to raise the front of the footrest.
2. Turn the setscrew anticlockwise to lower the front of the footrest.
JAZZY 1121/REV C/SEPTEMBER 2002
A D J U S T M E N T S
A D J U S T M E N T S
BALL DETENT PIN
Figure 10. Footrest (Shroud removed.)
WWW.PRIDEMOBILITY.COM
FOOTREST BRACKET
NUTS AND BOLTS
19