Operation with the engine off
Important note
The vehicle is equipped with an electro-hydraulically controlled
gearbox system by means of paddles on the steering wheel.
The default setting for the DCT gearbox is always "Automatic"
mode.
Every time the vehicle is started, the DCT gearbox is in "Auto
easy exit" mode unless the vehicle was in "Automatic" mode
when it was turned off.
To exit the "Auto easy exit" mode operate the UP or DOWN
paddle (while the vehicle is moving) or press the
on the central console.
����
Once the "System start-up" stage has been completed, the engaged
gear will appear on the DOT MATRIX display:
N (Neutral)
P (Parking);
R (Reverse);
1 (1
gear);
st
2 (2
gear), etc.
nd
Important note
Immediately release the UP and DOWN paddles and the button
R after the display shows that the gear has been engaged; a
button
AUTO
prolonged manoeuvre would cause the failure warning light to
turn on (see page 143) and triggering of the buzzer.
Important note
If the engine compartment lid is open or not properly closed,
none of the gears can be engaged. When the vehicle is
stationary, with the driver-side door open or not properly closed
and the brake pedal released, the system disengages the gear
engaged after approximately two seconds.
��
· About your vehicle ·
4
•
155