Reducing The Memorised Speed; Deactivating The Device; Rain Sensor - Ferrari California Owner's Manual

Each time the ring nut is turned corresponds to an increase in
speed of approximately 2 km/h whereas if the ring nut is kept up
the speed varies continuously.

Reducing the memorised speed

This can be done in two ways:
- by deactivating the device and then memorising the new speed
or
- by turning the ring nut B downwards (-) until it reaches the new
speed that will be automatically memorised.
Each time the ring nut is turned corresponds to a decrease in speed
of approximately 2 km/h whereas if the ring nut is kept down the
speed varies continuously.

Deactivating the device

Turn the ring nut to OFF or the ignition key to position 0. The
A
device is then automatically deactivated in one of the following
ways:
- by pressing the brake pedal or the clutch.
Warning
When driving with the device activated, do not put the shift
paddle in neutral.
Warning
If the device is malfunctioning or faulty, turn the ring nut to
OFF and contact the Ferrari Service Network.

Rain sensor

The rain sensor automatically adjusts the windscreen wiper timing
to the intensity of the rain during intermittent operation.
All functions controlled by the right-hand lever are unaffected.
The rain sensor automatically activates when the right-hand lever is
moved to AUTO and it has a range of adjustment which runs from
"wiper stationary" (when the windscreen is dry) to "fast continuous
operation" (with heavy rain).
To regulate the frequency of intermittent operation, with the lever
set to AUTO, turn the control C.
Turning the end knob counterclockwise, intermittent operation
varies from a maximum (fast intermittent operation) to a minimum
(slow intermittent operation).
Important note
The rain sensor function is reset by turning the ignition key to
position 0 and also by leaving the right-hand lever in position
AUTO. To reactivate it, turn the control to OFF and then again
to AUTO.
· About your vehicle ·
4
• 151