Ferrari California Owner's Manual page 140

Oil pressure
Indicates that the oil pressure is too low (priority
level 0).
Turn off the engine and contact the Ferrari
Service Network.
Indicates a pressure sensor failure (flashing)
(priority level 2).
On board diagnostic system (EOBD)
It indicates a malfunction in the emission control
system and in the ignition/injection system.
After turning the ignition key to position II, this
remains on for a self-check for a few seconds
following engine starting.
Cruise Control on
Indicates that the Cruise Control has been turned
on.
Running lights
When the running lights or low beams are turned
on.
Stop lights failure
Indicates a system failure or blowing of the STOP
light bulb (priority level 2).
Lights failure
Indicates a system failure or blowing of a bulb in
the running, direction indicators or rear fog lights
(priority level 2).
4
· About your vehicle ·
• 140
Number plate lights failure
Indicates a system failure or blowing of the
number plate light bulb (priority level 2).
Rear fog lights
When the rear fog lights are turned on.
Twilight sensor failure
Indicates a twilight sensor failure (priority level 2).
Hard top failure
Indicates a failure in the retractable hard top
(priority level 0).
The type of failure is specified by a special
message on the display.
High beams
When the high beams are turned on.
When the high beams are used to flash.
Right direction indicators
When the right direction indicators are activated.
Left direction indicators
When the left direction indicators are activated.
Hazard warning lights
When the hazard warning light is activated.