Starter Motor - Mercury MerCruiser D2.8L D-Tronic Service Manual

STARTING SYSTEM

Starter Motor

1. Apply a light coat of 2-4-C Marine Lubricant With Teflon to mounting surfaces and
fasteners prior to installation.
2. Position starter motor on engine.
3. Install lockwashers and nuts. Torque nuts to 68 Nm (50 lb-ft).
4. Connect wires to starter solenoid.
5. Coat terminals with Liquid Neoprene sealer.
6. Slide rubber boot over positive (+) terminal connection.
7. Connect battery cables to battery.
Page 4A-10
a
a
a - Lockwasher and Nut (1 Not Shown)
a - RED Wire
b - YELLOW/RED Solenoid Wire
c - Positive (+) Battery Cable
a
c
b
SERVICE MANUAL NUMBER 22
70810
70810
90-860074--1 FEBRUARY 2002