SERVICE MANUAL NUMBER 22
Installation
Engine Installation / Alignment
1. On Engines Where Engine Mounts WERE NOT Disturbed: Proceed to Step 3.
2. On Engines Where Engine Mounts WERE Disturbed: Ensure front mount adjusting
nuts are positioned midway on studs so that adequate up and down adjustment exists
for engine alignment.
3. Lubricate coupler splines with Engine Coupler Spline Grease.
Typical
4. Attach a suitable sling to lifting eyes on engine and adjust so that engine is level when
suspended. Refer to Removal for location of engine lifting eyes.
5. Lift engine into position in boat, using an overhead hoist.
90-860074--1 FEBRUARY 2002
a -
Coupler Splines
STERNDRIVE (MCM) MODELS
a
75592
Page 2A-7