Roland VersaStudio BN-20 Master Manual page 38

Performing Printing and Cutting Separately
Procedure

Display the BN-20 driver's Printing Preferences screen.
 P. 6, "How to Open the BN-20 Driver's Printing Preferences Screen"



Start printing.
 P. 23, "STEP 5 : Starting Print Output"
The crop marks are printed as shown in the figure.
Crop Mark
(Align point 3)
Crop Mark
(Align point 1)
Alignment marks and symbols drawn using a graphics program cannot be used as crop marks.
36
Chapter 2 Fully Utilizing the Machine
Select [Cropmark] on the [Printer Adjust-
ment] tab.
Select [Print].
When [Printing & Cutting] is selected, pull back the
media after printing the crop mark to start cutting
immediately. Cutting is performed by following the
crop mark.
Crop Mark
(Align point 2)
Crop Mark
(Base point)