Table of Contents
Advertisement
Figure N2: Double-Wide Lounger Assembly
The “adjustable” lounger can be placed into either an
upright position (Figure N2 above) or reclining position.
A locking hinge on the aft end will allow for a headrest in
the reclining position. Refer to Figures N10 & N11 at
the end of this section for drawings on double-wide
lounger operation.
In addition, the “adjustable” lounger is adjustable for-
ward and back. To adjust, turn the handle upwards and
push/pull the seat assembly. The total travel distance or
adjustment is approximately six (6) inches.
E. Bucket Seats
The adjustable bucket seat(s) is included on all seating
configurations for 210 Horizon - 265 Sundowner mod-
els. See Figure N3. To adjust, lift up on the metal re-
lease handle under the middle of the seat. Slide the
seat forward or aft to the desired position. The seat will
adjust approximately six (6) inches. See Figure N4.
L-Shape
Double-Wide
Lounger
(Option)
(Standard)
Figure N3: 210 Horizon - 265 Sundowner
Seating Configuarations
Horizon & Sundowner
Owner’s Manual
06/00
Pull release handle up to
Backrest
move forward and back.
Cushion
Friction Adjustment Knob
Both bucket seats are also design to swivel. This per-
mits the spotter to be in the proper position to watch
water-skiers or allows the driver to socialize when not
operating the boat. Depending upon which model you
have, the bucket seats may be limited in the amount
and direction of swivel possible.
The bucket seat also comes with a flip-up bolster. By
simply flipping up the bolster the driver is able to sit
higher in the seat. This is designed to give the driver
and passenger greater flexibility, increased visibility, and
riding comfort.
The bucket seats may or may not rotate com-
pletely 180
swivel available depends on the model you
have.
U-Wrap
When rotating the bucket seat, damage to seat,
(Option)
steering wheel (if applicable), and/or coaming
pad may result if attempting to rotate in the
wrong direction or over-rotating. DO NOT USE
FORCE to rotate the chair.
To rotate the bucket seat to face the aft position:
1. Tilt the steering wheel (if applicable) as far forward
as possible.
2. Slide the seat completely forward (as needed to
clear coaming/side pad) by using the lever located
underneath the seat, at the center. See Figure N4.
3. Locate the lever on the left side of the buckets slider
mechanism and pull to release the pin from the
pedestal. This will allow you to rotate the seat. The
seat may or may not allow a person to rotate the
seat while being seated. See Figure N4.
Figure N4: Bucket Seat Slider Base (Front View)
NOTICE
. The amount and direction of
o
NOTICE
Pull lever up to release
pin from pedestal to
swivel bucket seat.
Section N
Page 2
Hide quick links:
Advertisement
Table of Contents
