Table of Contents
Advertisement
EDITING
34
EN
Dubbing To A Video Unit Equipped
With A DV Connector (Digital
Dubbing)
It is also possible to copy recorded scenes from
the camcorder onto another video unit equipped
with a DV connector. Since a digital signal is
sent, there is little, if any, image or sound
deterioration.
Core filter
Video unit equipped with DV connector
To DV IN/OUT
DV cable (optional)
To DV IN/OUT
To use this camcorder as a player
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit
equipped with a DV input connector using a DV
cable as shown in the illustration.
3
Start playback on the camcorder. (
4
At the point you want to start dubbing, start
recording on the video unit. (Refer to the video
unit's instruction manual.)
5
To stop dubbing, stop recording on the video
unit, then stop playback on this camcorder.
NOTES:
It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
(
pg. 14)
If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not dubbed.
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 4. If
this occurs, turn off the power and make
connections again.
When using a DV cable, be sure to use the
optional JVC VC-VDV204U DV cable.
To use this camcorder as a recorder
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit
equipped with a DV output connector using a DV
cable as shown in the illustration.
3
Set the camcorder's Power Switch to
4
Set
to
"REC MODE"
5
Press the Recording Start/Stop Button to
engage the Record-Pause mode.
The "
" indication appears on the screen.
DV IN
6
Start playback on the player.
7
At the point you want to start dubbing, press
the Recording Start/Stop Button again to stop
dubbing. The
T
indication rotates.
8
Press the Recording Start/Stop Button again
to stop dubbing. The
9
Press
to return to the normal playback
8
mode.
NOTE:
Digital Dubbing is performed in the sound mode
recorded on the original tape, regardless of the
current "SOUND MODE" setting.
pg. 21)
"PLAY"
or
. (
pg. 26)
"SP"
"LP"
T
indication stops rotating.
(
pg. 24)
.
Advertisement
Table of Contents
