Dubbing To Or From A Video Unit Equipped With A Dv Connector (Digital Dubbing) - JVC GR-D238 Instructions Manual

Dubbing To Or From A Video Unit
Equipped With A DV Connector (Digital
Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if
any image or sound deterioration.
Core filter
To DV IN/OUT
DV cable
(optional)
To DV IN/OUT
Video unit equipped
with DV connector
To use this camcorder as a player
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit equipped with
a DV input connector using a DV cable as shown in the
illustration.
3
Set this camcorder's Power Switch to "PLAY" while
pressing down the Lock Button located on the switch.
4
Turn on the video unit's power.
5
Insert the source cassette in this camcorder.
6
Insert the recording cassette in the video unit.
7
Press 4/9 on this camcorder to start playback of the
source cassette.
8
At the point you want to start dubbing, engage the
video unit's Record mode.
9
To pause dubbing, engage the video unit's Record-
Pause mode and press 4/9 on this camcorder.
10
Repeat steps 7 – 9 for additional editing. Stop the
video unit and camcorder.
NOTES:
● It is recommended to use the AC Adapter as the power
supply instead of the battery pack. (
● If a blank portion or disturbed image is played back on the
player during dubbing, the dubbing may stop so that an
unusual image is not dubbed.
● Even though the DV cable is connected correctly,
sometimes the image may not appear in step 8. If this
occurs, turn off the power and make connections again.
● If SNAPSHOT is pressed during playback, only the original
playback image recorded on the tape is output from the DV
connector.
● When using a DV cable, be sure to use the optional
JVC VC-VDV204U DV cable.
To use this camcorder as a recorder
1) Perform steps 1 to 3 in "To use this camcorder as a
player".
2) Set "REC MODE" to "SP" or "LP". (
3) Insert the recording cassette in this camcorder.
4) Press the Recording Start/Stop Button to engage the
Record-Pause mode.
● The "
" indication appears on the screen.
DV. IN
5) Press the Recording Start/Stop Button to start
recording. The T indication rotates.
6) Press the Recording Start/Stop Button again to stop
recording. The T indication stops rotating.
NOTE:
Digital Dubbing is performed in the sound mode recorded on
the original tape, regardless of the current "SOUND MODE"
setting. ( pg. 15)
EDITING
25
EN
pg. 7)
pg. 14, 15)