Table of Contents
Advertisement
TROUBLESHOOTING
36
EN
If, after following the steps in the chart below, the
problem still exists, please consult your nearest
JVC dealer.
The camcorder is a microcomputer-controlled
device. External noise and interference (from a
TV, a radio, etc.) might prevent it from
functioning properly. In such cases, first
disconnect its power supply unit (battery pack,
AC Adapter, etc.) and wait a few minutes; and
then re-connect it and proceed as usual from
the beginning.
Power
No power is supplied.
The power is not connected properly.
HConnect the AC Adapter securely. (
The battery pack is not attached firmly.
HDetach the battery pack once again and re-attach
it firmly. (
pg. 12)
The battery is dead.
HReplace the dead battery with a fully charged
one. (
pg. 12)
Video Recording
Recording cannot be performed.
The tape's erase protection tab is set to "SAVE".
HSet the tape's erase protection tab to "REC".
(
pg. 17)
"TAPE END" appears.
HReplace with new cassette. (
The cassette holder cover is open.
HClose the cassette holder cover.
When shooting a subject illuminated by
bright light, vertical lines appear.
This is not a malfunction.
When the screen is under direct sunlight
during shooting, the screen becomes red or
black for an instant.
This is not a malfunction.
During recording, the date/ time does not
appear.
"DATE/TIME" is set to "OFF".
HSet "DATE/TIME" to "ON". (
HRe-read the sections Effects and "DIS".
HSet "ZOOM" to "64X" or "800X". (
HSet the TV to the mode or channel appropriate for
pg. 14)
HClose the cassette holder cover. (
HClean the video heads with an optional cleaning
HSet Focus to the Auto mode. (
pg. 17)
HClean the lens and check the focus again.
HDisengage the (
pg. 23, 25)
The LCD monitor or viewfinder indications
blink.
Effect and "DIS" functions that cannot be used
together are selected at the same time.
(
pg. 23, 24)
Digital Zoom does not work.
32X optical zoom is selected.
Video Playback
The tape is moving, but there is no picture.
Your TV has AV input terminals, but is not set to
its VIDEO mode.
video playback. (
pg. 22)
The cassette holder cover is open.
Blocks of noise appear during playback, or
there is no playback picture and the screen
becomes blue.
cassette. (
pg. 41)
Advanced features
The focus does not adjust automatically.
Focus is set to the Manual mode.
The lens is dirty or covered with condensation.
(
pg. 39)
Snapshot mode cannot be used.
The 16:9 wide mode (
selected.
16:9 indicator) 16:9 wide
mode. (
pg. 27)
pg. 24)
pg. 17)
pg. 28)
16:9 indicator) is
Advertisement
Table of Contents
