Notes On Using Smartmedia - JVC GC-S5 Instructions Manual

Notes on Using SmartMedia

Storing Data
In the situations listed below, recorded data may be erased (destroyed).
Please note that JVC accepts no responsibility whatsoever for the loss
(destruction) of recorded data.
• When the SmartMedia is used incorrectly by the owner or a third party
• When the SmartMedia is exposed to static electricity or electrical noise
• When the SmartMedia cover is opened or the SmartMedia is removed and
the camera is then switched off during data recording, during data erasing
(SmartMedia formatting) or during frame advance when images are being
played back.
Back up important data onto another medium (MO disk, floppy disk, hard
disk, etc.).
Notes on Handling SmartMedia
Never remove the SmartMedia or switch the camera off during data
recording, during data erasing (SmartMedia formatting) or during frame
advance when images are being played back. These actions could result in
damage to the SmartMedia.
Use only the SmartMedia specified for use with the GC-S5. The use of other
SmartMedia could damage the camera.
SmartMedia are precision electronic devices. Do not bend, drop, or subject
SmartMedia to excessive shocks.
Do not use or store SmartMedia in environments likely to be affected by
strong static electricity or electrical noise.
Do not use or store SmartMedia in very hot, humid or corrosive
environments.
Take care not to touch the SmartMedia's contact area or allow the area to
become soiled. Use a dry lint-free cloth to wipe away any soiling that does
occur.
To avoid damage caused by static electricity, always use the special static-
free case provided during transportation or storage, or keep the SmartMedia
in a storage case if available.
Do not carry SmartMedia in locations such as a trouser pocket. This could
subject the SmartMedia to excessive force when you sit down, thereby
damaging the SmartMedia.
The SmartMedia may feel warm when it is removed from the camera after
extended periods of picture taking or image viewing. This is normal and
does not indicate a fault.
Inserting a SmartMedia that is charged with static electricity into your
camera may result in a camera malfunction. If this occurs, switch the camera
off and then on again.
23