Item
Check All
Sectors
Enable HDD
Enable
Initialization
Power Setup
Item
Peak Power
Control
Power Save
Value
No
Yes
No
Yes
No
Yes
Value
Normal
Low
Enable
Disable
253
Description
Performs recovery of a defective HDD
sector information and a file system
mismatch as mentioned above.
It takes 30 to 40 minutes to complete
this function for an HDD of 10GB.
Even if a machine is inoperable at
installation because an HDD has
been damaged, you can make the
machine operable by setting to NO to
signify that no HDD is attached,
regardless of the existence of an
HDD. While NO is set, access to an
HDD results in FAIL because the HDD
is regarded as not attached even if the
HDD is operating normally.
Prevents a setup change
accompanying initialization of Block
Device (HDD, FLASH).
Description
The fuser of the printer has two
lamps. When the lamps turn on, the
printer's power draw increases
dramatically.
Normal: Both lamps light at the same
time. When this happens, the printer's
power draw increases dramatically.
Low: The lamps do NOT light at the
same time. The printer's electrical
draw increases, but not as
dramatically.
Enables/Disables the power save
mode.