Ethertalk - Oki C9600dn Configuration Manual

Troubleshooting:

EtherTalk

Not identified by the Chooser and the Setup Utility.
Turn the printer off and on again.
•
Make sure the network cable is correctly connected.
•
Change the cable and try again.
•
If the network resides in a Zone, make sure the correct Zone
•
name is selected in the Chooser.
Make sure the Zone name in the utility related to the NIC is the
•
same as the Zone name set in NIC.
Make sure AppleTalk, which is displayed at the right bottom of the
•
Chooser, is set to Enable. (In some OS versions Network is used
instead of AppleTalk.)
Make sure Ethernet is selected in AppleTalk. (In some OS
•
versions Network is used instead of AppleTalk.)
Make sure the print driver is selected in the Chooser.
•
Make sure the EtherTalk protocol is set to Enable.
•
Print the NIC settings (see page 12) and confirm that the
•
EtherTalk Port name is not blank.
Troubleshooting: EtherTalk • 213