Bushnell BackTrack Fishtrack Instruction Manual page 6

BaSic SeTuP
• Open battery cover and insert 3 AAA batteries (Fig 1,
pg 4). Record the serial # inside-you'll need it later to
register your FishTrack online. Close the cover.
• Go outdoors. HOLD POWER (1) (keep the button
pressed) until the display comes on. Wait for GPS
satellite lock (icon stops blinking) (11). This may take
a few minutes after the first power-up in a new area.
• Press SETUP (4). Press MARK (2), then press the TRIP
(3) or SETUP button to set the Hour for your area
(Fig. 2). Press the MARK button to return to the Setup
screen.
• To change the time and temp/distance formats, press
SETUP to select "12h" or "
set to "24h" or "
explained on page 6. Press POWER to exit Setup.
MaRkinG/ReTuRninG to a LocaTion
• Press POWER to select one of five Location icons or
up to 20 numbers (6) (Fish, Boat Ramp, Fishing Rod,
Dock, Hook, #1-20). While standing at the Location
you want to mark, HOLD MARK to save its position
in the FishTrack's memory (the display will change
as shown) (Fig. 4). You can now turn the power off
(HOLD POWER) and leave the location.
• To return to the location you marked, turn the
FishTrack on. Make sure the same icon or # you used
to mark the location is shown (if not, press POWER
to select it). The display indicates the direction and
distance back to the location (Fig. 5). Move in the
direction of the arrow, watching for the distance to
decrease. When you reach the location, the "Mark"
icon will flash in the center of the display.
6
F/yd", then press MARK to
0
C/m". (Fig. 3). The arrow's function is
0
Fig. 2
Fig. 3
Fig. 4
Fig. 5