1 - 10 RS507 Hands-Free Imager Product Reference Guide
Status Indications
The Imager has two Scan LEDs that provide identical indications. The Imager is also equipped with a beeper that
issues different beep sequences and patterns to indicate status.
Table 1-2
defines the LED and beep sequences indications that occur during normal operation and bar code
scanning.
Status Indications
Table 1-2
No.
1.
None
2.
Short green flashes
3.
None
4.
None
5.
None
6.
None
7.
None
8.
One green flash
9.
None
10
Red flash
11
Long red flash followed
by a green flash
NOTE When the Imager is connected by corded configuration, only "Proper scanning indication" and "Clean
Boot was perform successfully" status events are indicated.
Imager Standby Mode
To save battery power, the Imager goes into Standby when not active.
The Image resumes functionality when:
•
Bluetooth data is received from the mobile computer (in cordless configuration)
•
Scan trigger is pressed
•
Restore key is pressed
•
Motion is detected (in cordless configuration)
•
Incoming data from mobile computer is sensed (in corded configuration).
LED
Beep Indication
High/low
None
Low/high
High/low
High/low/high/low
Long low/ long high/
Long low/ long high/ Long low/
long high/
High
4 long beeps
2 short beeps every 15 seconds
High/low High/low
Description
Bluetooth communication is disconnected.
Attempting to connect over Bluetooth.
Imager is connected over Bluetooth.
Bluetooth communication is disconnected -
Imager is out of range.
Properly decoded scan of Bluetooth pairing
bar code.
Bluetooth connection attempt failed.
Bluetooth connection attempt is rejected.
Proper scanning indication.
No Bluetooth communication after
re-connection failure.
Low battery.
Clean Boot was performed successfully.