Chapter 3: Getting To Know The Router; The Router's Ports; Figure 3-1: Back Panel - Linksys WRP200 User Manual

Wireless-G Broadband Router with 2 Phone Ports

Chapter 3: Getting to Know the Router

The Router's Ports

The Router's ports and the Reset button are located on a side panel of the Router.
Internet This Internet port connects to your cable or DSL modem.
Phone1 For your primary Internet telephone line, the Phone1 port allows you to connect the Router to
your telephone (or fax machine) using an RJ-11 telephone cable (not included).
Phone2 For your secondary Internet telephone line, the Phone2 port allows you to connect the Router
to your second telephone (or fax machine) using an RJ-11 telephone cable (not included).
Ethernet 1-4 These three Ethernet ports connect to network devices, such as PCs, print servers, or
additional switches.
Reset Button There are two ways to reset the Router's factory defaults. Either press the Reset button, for
approximately five seconds, or restore the defaults from the Administration tab - Factory
Defaults in the Router's Web-based Utility.
NOTE: Depending on your Internet phone service provider's policies, the Factory Defaults tab may be
protected by a password available only from your Internet phone service provider. For more
information, contact your Internet phone service provider.
Power The Power port is where you will connect the power adapter.
Chapter 3: Getting to Know the Router
The Router's Ports

Figure 3-1: Back Panel

NOTE: If you use the Reset button, the Router's
settings—except for the Internet phone service
settings—will be reset to their factory defaults.
6