Connect Gas Supply Line - Vermont Castings 3225 Installation And Operating Manual

Rear Log
Bracket
Fig. 38 Radiance firebox.
LG156
Radiance logs
4/23/01 djt
Right Rear Log
Left Rear Log
Left Bracket
Fig. 39 Install the left and right rear logs and the right log.
LG156
4. Install the right log by engaging hole on the bottom Radiance logs
with pin on the right rear log. (Fig. 40) Set the bottom
4/23/01 djt
of the log on the bracket and bring forward to come
in contact with decorative grate on right.
5. Loosely sprinkle the lava rocks directly on top of the
burner just behind decorative grate. (Fig. 41) Use
the lava rock to cover brackets on the burner. Do
not place lava rocks toward back of burner. The lava
rock is shipped inside the bag assembly.
20004188
LG158
Right Log
Right
Decorative
Bracket
Grate
LG156
Radiance Direct Vent /Natural Vent Gas Heater
Log rests on
decorative grate
Fig. 40 Completed log installation.
LG155
Radiance logs
Left Rear Log
installed
4/24/01 djt
Decorative Grate
LG160
Fig. 41 Lava rock placement.
Connect the Gas Supply Line
Check the Rating Plate attached by a steel cable to the
firebox, to confirm that you have the appropriate firebox
for the type of fuel to be used. The Radiance may be
converted from one gas to another using the appropri-
ate Fuel Conversion Kit listed on page 30.
In the U.S.; Gas connection should be made in ac-
cordance with current National Fuel Gas Code, ANSI
Z223.1/NFPA 54. Since some municipalities have addi-
tional local codes, be sure to consult your local authority.
In Canada; consult the local authority and CSA-B149.1
installation code.
Always check for gas leaks with a mild
soap and water solution. Do not use an
open flame for leak testing.
Light the pilot according to the directions on Page 24,
before going to the next step.
Lava Rock
Right Rear
Top View
Log
Lava rock may
be placed in
this area
LG160
RNV logs
top view
6/4/01 djt
LG155
21