Grundig CUC 7303 Service Manual page 11

The remote control buttons
0/AV...9 Select programme pos. (also AV);
switch on from standby..
Switch to standby.
Brightness.
TXT Teletext on/off.
Colour contrast.
Display/suppress programme
i
position number
Display/suppress Teletext overview.
Sound on/off (mute).
Select programme positions;
P+, P–
move cursor.
P+ Switch on from standby.
Change and activate certain
OK
functions.
– + Volume;
move cursor.
PC/AUX Preselect button for various
functions.
Press and hold down 4 seconds to
call up ATS.
Further functions
Change b/w contrast: Press the PC/AUX button then change the contrast
using the +
– button.
Programme Sleep Timer (switch-off delay 01...99 min.):
Press the PC/AUX and then the TXT button. Use the 0...9 buttons to enter
the switch-off delay.
!
Every changed value (volume, etc.) is stored after approx. 8 sec.
!
Pressing PC/AUX and then OK recovers the factory presettings.
!
Tint has no function on this set.
11
1 2 3
1
4 5 6 +
7 8 9
–
0/AV TXT +
PC/AUX
1
P+ –
– OK +
P–
TP 711
!
11
Connecting a video recorder, satellite receiver
or decoder (descrambler)
Connection
Connect with an AV cable to the AV socket at the back of the set.
Operating the connected unit
Start playback on the video recorder or switch on the SAT receiver. When
connecting a decoder, observe the chapter "Assigning programme posi-
tions manually" on page 4.
In the menu, "ON" must be selected under "DEC" for the programme posi-
tion concerned.
Connecting several external units
• For TV reception via a cable system:
Descrambler → Video recorder → TV receiver
• For satellite TV reception:
Descrambler → Satellite receiver → TV receiver
This unit conforms to VDE safety regulations and directives of the Deutsche
Bundespost (German Federal Post Office; see certification mark on the type
sticker on the rear of the unit), as well as all relevant ordinances governing
X-ray emissions. The picture tube, which emits X-rays, is sufficiently shiel-
ded and therefore represents no danger. Accelerating voltage is max. 25 kV
with a mean beam current of 1 mA.
Unauthorized tampering with the unit, in particular making adjustments to
the high voltage system, or installing a different picture tube, can consider-
ably increase X-ray emissions. Units so altered no longer conform to appli-
cable safety regulations and may not be operated.
220-240V, 50/60Hz (power supply control range 165 – 265V)
Power consumption approx. 55 W; in standby 10 W.
Sound output: 2 W music power (1 W sine power).
The mains cable can be plugged into the set. If you need a replacement
cable, order it at an after-sales service under the number 8290-991-307.
Subject to alterations. E. and O.E.