Grundig CUC 7303 Service Manual page 10

Note:
This chapter contains excerpts from the operating instructions
T 51-720 text GB. For further particulars please refer to the appropriate user
instructions the part number of which is indicated in the relevant spare parts
list.
1st possibility
The Automatic Tuning System ATS
This automatic tuning system scans the entire reception range and auto-
matically stores all found programmes.
How to proceed:
1 Switch the TV set on from standby with one of the buttons 1...9.
2 Press the PC/AUX button for approx. 4 sec. until the ATS menu appears.
Start the tuning system with the OK button.
3
The station search procedure may last one minute and longer.
When the station search is completed, the televsion is ready for operation.
Have a good time with your new television set!
If you are not satisfied with the automatic assignment of the programme
positions, you can change the order of the programmes stored in the
station positions according to your personal preferences.
The dialogue line as user's guide
The line which is displayed at the bottom of the menus shows you which
buttons on the remote control handset are to be used to change settings.
!
The , , , signs on the picture screen are symbols for the following
buttons on the remote control handset:
= P- and P+ buttons
,
= – and + buttons Cursor movement to the left/right and
,
In the following text, the illustrations of the buttons instead of the symbols
will be shown.
Exchanging programme positions
Example: The channel stored in programme position 2 is to be moved to
programme position 5.
1 Select programme position 2.
10
Press the i and then the OK button. The programme menu is displayed.
2
Cursor movement up/down and function
selection.
function selection.
3 Under "PR", enter the new programme position 05 with the buttons 1...9.
4 Press the OK button. The procedure is completed.
i
5 Press the button to return to TV mode.
2nd possibility
Assigning programme positions manually
i
1 Pres the and then the OK button. The programme menu is displayed.
P+ PR B TUNE S
14 UHF 0
--- -------- -------------- -------- -------------------- ------
Sort 0...9 OK
Use the – or + button to select the desired menu item.
2 Under "PR" select the programme position to be assigned with the P+/P-
button.
"B" Selct the band UHF (C21-C69) or ----.
If ---- is selected under "B", the following programme posi-
tions can no longer be selected using the P+ and P- buttons.
" "TUNE" Press the P+ or P– button to display the manual search
menu.
Press and hold down the –
search. The search stops at each programme which can be
received. If finetuning is necessary (programme positions
1-20), briefly press the –
picture and sound quality is obtained.
i
Press the button to return to the programme menu.
" "S" The televsion standard (norm) cannot be changed.
" "DEC" If an encoded programme is assigned to this programme
position and an appropriate descrambler (decoder) is
connected, then select "ON".
3 Press the OK button to store the modified settings.
i
4 Press the button to return to the TV picture.
DEC
OFF
Dialogue line
i
or + button to start the
or + button until the best
10