Removing The Rinse Agent Dispenser Regulator - Hobart CLF26D-10 Instruction Manual

INSTRUCTION MANUAL FOR DISHWASHERS
The internal components (boot, ...) are subject to wear, therefore they must be periodically replaced.
In case of intervention on the rinse aid dispenser, carry out the following steps:
1) Drain the appliance as
described in "Discharging
the appliance".

9.5 Removing the Rinse Agent Dispenser Regulator

2) Loosen the four
screws holding the
dispenser.
3) Replace any faulty
components.
GB
4) Refit the dispenser
correctly centring the
rubber bellow.
Page 15 of 15