Chap 8 Disposal; Chap 9 Repair Operations; Special Precautions; Restoring The Safety Thermostat - Hobart CLF26D-10 Instruction Manual

INSTRUCTION MANUAL FOR DISHWASHERS
GB
There are no materials on our machines that require special disposal procedures.
•
Before performing any operation always unplug appliance from outlet and detach
from water mains. Always wear protective gloves.
•
Always refer to the technical documentation and specifications enclosed with
appliance.
•
At the end of any intervention, replace all safety features previously removed.
•
Do not leave foreign objects inside appliance.
•
Do not tip over appliance after setup.
The silicon pipe from the detergent dispenser is subject to wear and must therefore be replaced
periodically. Proceed as follows:
1) Remove the clear
cap
If replacing the pressure switch, or its drum, or in the case of the appliance accidentally tipping over,
proceed as follows:
1) The pressure switch is
situated either at the back or top
of appliance
Page 14 of 15
To resume the operation, eliminate the cause of the
problem and press the red button on the thermostat to
reengage.

9.3 Replacing the Detergent Dispenser Pipe

2) Loosen the pipe by
turning the gear
2) Remove the tube and, if
necessary, replace the
pressure switch.

Chap 9 REPAIR OPERATIONS

9.1 Special Precautions

9.2 Restoring the Safety Thermostat

3) Replace the silicone
pipe

9.4 Replacing the Tank Pressure Switch

3) Blow inside the tube to eliminate
condensation. Refit the components
in reverse order.

Chap 8 DISPOSAL

4) Shut the clear cap