Adjusting The Volume Of Pages; Configuring Group Paging Mode - Polycom SoundStation Duo Installation Instructions And User Manual

• If your phone isn't allowed to receive pages during active calls, the page
displays on your phone in a 'Pending' state, as shown next. When a page
is pending, you can't hear the page. To place the original call on hold and
listen to the page, scroll to the page, and then press the Accept soft key. To
remove the page from the screen, press the Reject soft key.
If it's a Priority or Emergency page, the page displays on your screen and
immediately plays. You'll hear both the original call and the page. To listen to
only the page, hold or end the original call.

Adjusting the Volume of Pages

You can adjust the volume of pages while they play. During a page, press
either or
If you adjust the volume of a non-emergency page, your phone will use the
adjusted volume for subsequent non-emergency pages. However, if you
adjust the volume of an Emergency page, your phone won't use the adjusted
volume for subsequent Emergency pages. All Emergency pages play at the
same volume, until you adjust it.

Configuring Group Paging Mode

You can configure Group Paging mode by doing the following:
• Updating the default paging group
• Updating paging group subscriptions
• Allowing or disallowing pages to play during active calls
Updating the Default Paging Group
If you don't select a group to send your pages to, your page will automatically
go to the default paging group, Paging Group 1. If you want, you can change
the default paging group.
Using Your Conference Phone in SIP Mode
to raise or lower the page volume.
103