Over The Internet - Q-See QT Series User Manual

OVER THE INTERNET

This allows you to connect to cameras in a
completely different location.
• You will need to use the IP Tool (PC) or
the NVMS software (Mac) included on
the Manuals and Software CD or by
download from www.Q-See.com/support.
NVR
• Follow instructions in the IP Camera
Manual (also on the CD) to get the IP
POE POE
address of the camera.
Block Block
• Once you have the IP address of the
camera, you can add it to the NVR through
the following steps:
STEP 1. Connect the camera to a POE Injector, such as Q-See's QAPE model.
STEP 2. Plug the injector into a power outlet.
STEP 3. Use a network cable to connect the injector to a network port.
OBTAIN IP ADDRESS:
STEP 4. Install the IP Tool sofware
onto a Windows PC connected to the
same network as the remote camera.
STEP 5. Launch the IP Tool sofware. It
will locate the camera and display its
information.
NOTE! The IP address shown
is only for your local network.
The NVR cannot use this to
connect to the camera over
the Internet.
Network Network
Router
Port
POE POE
POE
Block Block
Internet
Internet
NVR
Router/
Network Network
Modem
Port
POE POE
Block Block
PICTURE 2-17
PICTURE 2-18
PICTURE 2-19
Router/
Modem
POE
POE
21