Disassembly And Assembly - Epson Stylus Photo 1390 Service Manual

EPSON Stylus Photo 1390/1400/1410
Stylus Photo 1390
Start
"Rear Housing"
4.2.1.1 page 78
"Board Assy"
"Side Housing"
4.2.5.1 page 90
4.2.1.2 page 78
"Upper Housing"
4.3.1 page 128
"Lower Housing and
"Paper EJ
Printer Mechanism"
Frame Assy"
4.2.1.5 page 82
4.3.2 page 129
"Paper EJ
"Waste Ink Pad"
Frame Assy"
4.2.2 page 84
4.3.2 page 129
"Front Paper Guide and
"Ink System Unit"
Paper Eject Roller"
4.2.6.9 page 110
4.2.6.13 page 117
"PF Encoder
Sensor Holder"
4.2.8.4 page 126
"Upper Paper
Guide Assys"
4.2.6.12 page 115
"PF Roller Shaft"
4.2.6.14 page 119

DISASSEMBLY AND ASSEMBLY

See Figure 4-4
C H E C K
P O I N T does not have the PictBridge Unit and CD-R print-related units, its disassembly/assembly flow
is different from that of Stylus Photo 1400/1410.
Disassembly procedures of some parts of Stylus Photo 1390 are different from those of Stylus
Photo 1400/1410. See
Stylus Photo 1400 was used to illustrate these disassembly and assembly procedures in this
chapter except for Section 4.3.
indicates that the disassembly procedure is different from Stylus Photo 1400/1410.
"PF Encoder
"APG Assy"
Sensor Holder"
4.2.6.4 page 96
4.2.8.4 page 126
"Front Paper Guide
"PF Motor"
Pad"
4.2.7.2 page 123
4.2.3 page 85
Figure 4-5. Disassembly Flowchart of Stylus Photo 1390
Disassembly/Assembly Procedures
for disassembly flowchart of Stylus Photo 1400/1410. Since Stylus Photo 1390
"4.3 Procedure Specific to Stylus Photo 1390" on page 128
"CR Motor"
"ASF Assy"
4.2.7.1 page 122
4.2.4 page 86
"PE Sensor Holder"
"APG Assy"
4.2.6.4 page 96 4.2.8.1 page 124
"Release Holder Assy"
4.2.6.10 page 113
"FLAG Release Assy"
4.2.6.11 page 114
"PE Sensor Holder"
4.2.8.1 page 124
"Upper Paper
Guide Assys"
4.2.6.12 page 115
for details.
"CR Scale"
4.2.6.1 page 92
"CSIC Assy"
4.2.6.2 page 94
"Printhead"
4.2.6.3 page 95
"APG Assy"
4.2.6.4 page 96
"Carriage Shaft
and Carriage Unit"
4.2.6.5 page 98
"CR Encoder
"PW Sensor"
Sensor Board"
4.2.8.2 page 125
4.2.8.3 page 126
The boxes shown by dashed lines indicate that the part/unit
need to be removed to go to the next step, but does not indicate
the shortest way to remove the part/unit.
Revision B
77