Paper Ej Frame Assy - Epson Stylus Photo 1390 Service Manual

EPSON Stylus Photo 1390/1400/1410
5. Disconnect the Panel FFC from connectors CN1 on the Switch Board.
CN1
Guide Pin
Figure 4-148. Disconnecting the Panel FFC
6. Remove the Guide Pins from the two tabs shown in
Upper Housing upwards.
Align the Guide Pins with the positioning holes of the Upper
Housing. See Figure 4-147.
Tighten the screws in the order shown in
DISASSEMBLY AND ASSEMBLY
Panel FFC
Figure 4-147, and remove the
Figure 4-147.
Procedure Specific to Stylus Photo 1390
4.3.2

Paper EJ Frame Assy

1. Remove the Upper Housing. See section 4.3.1 on page 128.
2. Remove the Left Frame Support Plate.
3. Put back the rotation position of the Right PG Cam.
4. Remove the four C.B.S. 3x6 screws that secure the Paper EJ Frame Assy.
Tabs
2
3
Paper EJ Frame Assy
Figure 4-149. Screws that Secure the Paper EJ Frame Assy
Revision B
See Step 2 in Section 4.2.6.5 on page 98.
1
4
Tabs
2) C.B.S. 3x6
(8±1 kgf.cm)
129