Sharp Metal Edges; Method For Making Csic Board Removal Tool - Epson Stylus Photo 1390 Service Manual

EPSON Stylus Photo 1390/1400/1410

4.1.5 Sharp Metal Edges

During disassembly/reassembly of the Stylus Photo 1390/1400/1410,
C A U T I O N
extra care must be taken to avoid injury from sharp metal edges,
especially from the edges shown below.
Board Shield Plate
Main Frame
Main Frame
Main Frame
Figure 4-1. Parts with Sharp Metal Edges
DISASSEMBLY AND ASSEMBLY
USB Connector of
PictBridge Unit*
*Stylus Photo1390 does not have this unit.
Main Frame
Main Frame
Overview

4.1.6 Method for making CSIC board removal tool

The CSIC board (refer to p94) can be easily removed by using a special tool. The
method for making the tool is described below.
1. Prepare a handle part of a clip, or a similar metal wire piece.
Clip
Figure 4-2. Method for making CSIC Board Removal Tool (1)
2. Bend the metal wire into dimensions described below.
25mm
50mm
Figure 4-3. Method for making CSIC Board Removal Tool (2)
Revision B
Handle part
7mm
Special Tool
75