Ptz Camera Connection - Watchguard DVR8ENT3 Product Manual

8 channel h.264 dvr with push video notification
Table of Contents

Advertisement

2.2.2 PTZ Camera Connection

The following description is taking our brand's PTZ camera as an example.
For DVR setting to control the PTZ camera, please refer to "5.6 PTZ Camera Setting" at
page 28. For detailed PTZ camera control and operation, please refer to its own user
manual.
RS485-A: Red wire
RS485-B: Green wire
The RJ11 cable is not supplied in the sales package.
STEP 1: Get a RJ11 cable with the proper length to your connection.
Different RJ11 connector may have different wire layout, so the connection
might be different. If you cannot control the DVR after connection, please
reverse the RJ11 cable connection with the DVR.
STEP 2: Remove one end of the insulating coating of the RJ11 cable.
Remove one end of the insulating coating of the RJ11 cable to find the
RS485-A and the RS485-B wires, and remove the insulating coating to reveal
the naked wires for further connection.
STEP 3: Twist the RS485-A and RS485-B wires of the RJ11 cable and the speed
dome camera together.
Twist the RS485-A (red) and RS485-B (green) wires of the RJ11 cable to the
RS485-A (brown) and RS485-B (orange) wires of the speed dome camera. To
protect the naked wires, use the insulation tape to cover on the twisted wires.
STEP 4: Connect the other end of the RJ11 cable to DVR.
Solder the RS485-A (red) and RS485-B (green) wires of the RJ11 cable to the
corresponding pins on the solder side of the optional D-Sub connector.
For DVR PIN configuration, please refer to "APPENDIX 6 PIN
CONFIGURATION" at page 72. For connection details, please check with your
installer.
RJ11 cable
7
CONNECTION AND SETUP

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents