Metrologic MS1633 FocusBT Installation Manual page 9

Cerner Classic Configuration (Continued)
4) Next scan the "Bluetooth Address Code" Barcode on the top of the CodeXML Modem.
Note: Please wait for a Low / High beep before proceeding. (About 10 seconds)
At this point the scanner is configured for the Cerner HNA Classic environment using a Carriage
Return suffix.
Please proceed to the section titled "Symbology Selection"
© Cerner Confidential and Proprietary All rights reserved. This document contains confidential information, which may not be
reproduced or transmitted without the express written consent of Cerner Corporation.
Disable CR Suffix
³ 1 1 6 6 0 3
Disable LF Suffix
³ 1 1 6 6 0 2
Enable CodeXML Protocol
³ 1 2 5 6
Enter/Exit Config Mode
³ 9 9 9 9 9 9
MS1633 Focus BT Scanner Installation Guide
1 7
9