Show Firmware Revision - Metrologic MS1633 FocusBT Installation Manual

Show Firmware Revision

Follow this procedure to display the firmware revision of your scanner.
1. Bring up Microsoft Word, WordPad or Notepad and make sure your curser is in the
editors window.
2. Scan the following barcode.
Note: be careful not to open or click any other windows after you enter scan count mode.
You should now be seeing something that looks like this:
118016 1 2127 2127 15370
0 0 0 15370
0 0 0 15370
0 0 0 15370
0 0 0 15370...
Note: The last block of numbers is the firmware revision level. In this case it would be: 15370.
Scan the following barcode to turn off Scan Count.
© Cerner Confidential and Proprietary All rights reserved. This document contains confidential information, which may not be
reproduced or transmitted without the express written consent of Cerner Corporation.
Scan Count Mode On
³ 1 1 8 0 1 6
Scan Count Mode Off
³ 1 1 8 0 0 6
MS1633 Focus BT Scanner Installation Guide 39