Applying Power With Power Adapter; Making Lan Connections; Making Utp Connections - KTI Networks KFC-200 Installation Manual

2.4 Applying Power with Power Adapter

The device provides a DC power jack for receiving DC power input from an external AC-DC power adapter.
One power adapter is packed in each product package. Consult your purchasing agency for the right part
number which matching the operating rating you require.
Note: Before you begin the installation, check the AC voltage of your area. The AC-DC power adapter should
have the AC voltage matching the commercial power voltage in your area.

3. Making LAN Connections

3.1 Making UTP Connections

The copper ports support the following connection types and distances:
Network Cables
10BASE-T: 2-pair UTP Cat. 3,4,5 , EIA/TIA-568B 100-ohm
100BASE-TX: 2-pair / 4-pair UTP Cat. 5, EIA/TIA-568B 100-ohm
Link distance: Up to 100 meters
Auto MDI/MDI-X Function
This function allows the port to auto-detect the twisted-pair signals and adapts itself to form a valid MDI to
MDI-X connection with the remote connected device automatically. No matter a straight through cable or
crossover cable connected, the port can sense the receiving pair automatically and configure self to match the
rule for MDI to MDI-X connection. It simplifies the cable installation.
Auto-negotiation Function
The port is featured with auto-negotiation function and full capability to support connection to any Ethernet
devices. The port performs a negotiation process for the speed and duplex configuration with the connected
device automatically when each time a link is being established. If the connected device is also
auto-negotiation capable, both devices will come out the best configuration after negotiation process. If the
connected device is incapable in auto-negotiation, the switch will sense the speed and use half duplex for the
connection.
-12-