3. Making Network Connections Two Switched Ports Configuration Switches Port 1, Port 2 SW1 Off Auto-negotiation is enabled. Auto-negotiation is disabled. Port 1, Port 2 SW2 Off 100Mbps is used. (When SW1 = On) 10Mbps is used. (When SW1 = On) Port 1, Port 2 SW3 Off Full-duplex is used.
Important Note: If any change are made to the configuration switch settings, the power to the unit must be turned off and turned on again before the changes can take effect. TP Ports Jack Function MDI-X jack for Port #1 MDI jack for Port #1 MDI-X jack for Port #2 MDI jack for Port #2...
Fiber Port and Fiber Connection Model /T model /C model /S series Fiber mode Multimode Multimode Single mode Wavelength 1300 m 1300 m 1300 m Connectors Multimode fiber: 50/125, 62.5/125, 85/125, 100/140 m Single mode fiber: 9/125 m...
Connected device Duplex type Maximum length 100Base-FX NIC card Half-duplex 400 meters 100Base-FX NIC card Full-duplex 2K meters 100Base-FX hub port *1 Half-duplex 185 meters 100Base-FX hub port *2 Half-duplex 110 meters 100Base-FX switched port Half-duplex 400 meters 100Base-FX switched port Full-duplex 2K meters *1 : One Class II hub network *2 : Two Class II hub network...
4. Interpreting LED Indicators Power State Indication Interpretation Normal The power of the unit is on. Problem No power is being supplied to the unit. Link/Act. (Link/Activity) State Indication Interpretation Normal An active link is established. Normal No active link Blink Normal There are data transfer activities...