KVH Industries V7 User Manual page 28

TracPhone V7 User's Guide
Chapter 3 - Configuration
Defining an RF Radiation Hazard Zone
26
Follow the steps below to configure an RF radiation hazard zone.
1. Determine the necessary azimuth range for the RF
hazard zone. You will need to enter the beginning and
ending azimuths that define the outer boundaries of the
zone, relative to the antenna's forward arrow, which
should be pointing toward the bow (see Figure 3-2).
NOTE: Each RF hazard zone must span at least 5º. Therefore, be sure
to set beginning and ending azimuths at least 5º apart.
Figure 3-2 Beginning and Ending Azimuths Defining RF Radiation Hazard Zone
315
Forward
Antenna
270
225
2. Press MENUS until the display shows
"CONFIGURATION."
CONFIGURATION
NEXT MENU
Beginning
Azimuth
RF Radiation
015
Hazard Zone
000
(Example)
Ending
Azimuth
080
090
135
180
ACCEPT