Regular Maintenance; Maintenance Schedule; Checking Tire Pressures - Snapper LT-200 Series Operator's Manual

MAINTENANCE SCHEDULE & PROCEDURES
The following schedule should be followed for normal care of your tractor and mower.
SAFETY ITEMS
Check Safety Interlock System
Check Tractor Brakes
Check Mower Blade Stopping Time
TRACTOR MAINTENANCE ITEMS
Check Tractor/Mower for loose hardware
Check / Clean Cooling Fins (If Equipped)
Check / Adjust PTO Clutch
Lubricate Tractor & Mower **
Lubricate Rear Axle Shafts
Clean Battery & Cables
Check Tire Pressure
Clean Deck & Check/Replace Mower Blades**
ENGINE MAINTENANCE ITEMS
Check Engine Oil Level
Check / Change Engine Air Filter *
Change Engine Oil *
Change Engine Oil & Filter *
Inspect Spark Plug(s) *
Check / Replace Fuel Filter *
* Refer to engine owner's manual. Change original
engine oil after initial break-in period.
** More often in hot (over 85° F: 30° C) weather or
dusty operating conditions.
Check Tire Pressures
Service Interval: Every 25 Hours
Tire Pressure should be checked periodically, and main-
tained at the levels shown in the chart. Note that these
pressures may differ slightly from the "Max Inflation"
stamped on the side-wall of the tires. The pressures
shown provide proper traction, improve cut quality, and
extend tire life.
Before Every 5 Every
Each Hours 25
Use Hours
Before Every 5 Every
Each Hours 25
Use Hours
•
Before Every 5 Every
Each Hours 25
Use Hours
•
Size
22 x 10.0-8
20 x 8.0-8
15 x 6.0-6
Figure 9. Tire Pressure
19
Regular
Maintenance
Every Every
100 250
Hours Hours
•
Every Every
100 250
Hours Hours
•
•
•
•
•
•
Every Every
50 100
Hours Hours
•
• •
•
PSI bar
10 0,68
10 0,68
12-14 0,82-0,96
Spring
& Fall
•
•
•
Spring
& Fall
Yearly
Spring
& Fall
•
•