Table of Contents
Advertisement
USB DEVICE SETTING:
The options for these items are found in its sub menu. By pressing the
<ENTER> key, you are prompt to enter the sub menu of the detailed options
as shown below:
USB 1.0 Controller
USB 2.0 Controller
USB Operation Mode
USB Keyboard Function
USB Mouse Function
USB Storage Function
*** USB Mass Storage Device Boot
↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
Descriptions on each item above are as follows:
1. USB 1.0 CONTROLLER
This should be enabled if your system has a USB installed on the
system board and you want to use it. Even when so equipped, if you
add a higher performance controller, you will need to disable this
feature.
2. USB 2.0 CONTROLLER
Enable the USB 2.0 controller.
3. USB OPERATION MODE
Select USB operation speed. Configuration options: [Full/Low Speed],
[High Speed].
4. USB KEYBOARD FUNCTION
Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have a USB keyboard.
5. USB MOUSE FUNCTION
PMB-732LF USER
Phoenix – Award CMOS Setup Utility
USE Device Setting
F6:Fail-Safe Defaults
'
S MANUAL
Chapter 4 Award BIOS Setup
[Enabled]
[Enabled]
[High Speed]
[Enabled]
[Enabled]
[Enabled]
Setting ***
F7:Optimized Defaults
Item Help
Menu Level ►
[Enable] or [Disable]
Universal Host
Controller Interface for
Universal Serial Bus.
Page: 4-17
Advertisement
Table of Contents
