Table of Contents
Advertisement
ONCHIP IDE DEVICE:
The options for these items are found in its sub menu. By pressing the
<ENTER> key, you are prompt to enter the sub menu of the detailed options
as shown below:
IDE HDD Block Mode
IDE DMA transfer access
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
On-Chip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
SATA Mode
LEGACY Mode Support
↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
Descriptions on each item above are as follows:
1. IDE HDD BLOCK MODE
Block mode is also called block transfer, multiple commands, or
multiple sector read/write. If your IDE hard drive supports block mode
(most new drives do), select Enabled for automatic detection of the
optimal number of block read/writes per sector the drive can support.
2. IDE DMA TRANSTER ACCESS
To Enable/Disable the IDE DMA transfer access
3. IDE PRIMARY/ SECONDARY MASTER/SLAVE PIO
The four IDE PIO fields allow you to set a PIO mode (0-4) for each of
the four IDE devices that the onboard IDE interface supports. Modes
0 through 4 provide successively increased performance. In Auto
mode, the system automatically determines the best mode for each
device.
PMB-732LF USER
Phoenix – Award CMOS Setup Utility
OnChip IDE Device
F6:Fail-Safe Defaults
'
S MANUAL
Chapter 4 Award BIOS Setup
[Enabled]
[Enabled]
[Auto]
[Auto]
Menu Level ►
[Auto]
[Auto]
If your IDE hard drive
[Enabled]
supports block mode
[Auto]
select Enabled for
[Auto]
automatic detection of
[Auto]
the optional number of
[Auto]
block read/writes per
[IDE]
sector the drive can
[Disabled]
support.
F7:Optimized Defaults
Item Help
Page: 4-13
Advertisement
Table of Contents
