Protech Systems PMB-732LF User Manual page 70

Chapter 4 Award BIOS Setup
5. IR TRANSMISSION DELAY
This item allows you to enable/disable IR transmission delay.
6. UR2 DUPLEX MODE
This item allows you to select the IR half/full duplex function.
7. USE IR PINS
This item allows you to select IR transmission routes, one is RxD2m,
TxD2 (COM Port) and the other is IR-Rx2Tx2.
8. ONBOARD PARALLEL PORT
This item allows you to determine access onboard parallel port
controller with which I/O address.
9. PARALLEL PORT MODE
Select an operating mode for the onboard parallel (printer) port.
Select Normal, Compatible, or SPP unless you are certain your
hardware and software both support one of the other available modes.
10. ECP MODE USE DMA
Select a DMA channel for the parallel port for use during ECP mode.
11. PWRON AFTER PWR-FAIL
This item allows you to select if you want to power on the system after
power failure. The choice:Off,On,Former-Sts.
ONBOARD SERIAL PORT 3/4:
Select an address and corresponding interrupt for third and forth serial port.
WATCH DOG SUPPORT:
To select watch-dog times.
Page: 4-16
PMB-732LF USER
'
S MANUAL