Table of Contents
Advertisement
SUPER IO DEVICE:
The options for these items are found in its sub menu. By pressing the
<ENTER> key, you are prompt to enter the sub menu of the detailed options
as shown below:
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
RxD, TxD Active
IR Transmission Delay
X UR2 Duplex Mode
X Use IR Pins
Onboard Parallel Port
Parallel Port Mode
X ECP Mode Use DMA
PWRON After PWR-Fail
↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
Descriptions on each item above are as follows:
1. ONBOARD FDC CONTROLLER
Select Enabled if the system has a floppy disk controller (FDC) installed
on the system board and you wish to use it. If you install and-in FDC or
the system has no floppy drive, select Disabled.
2. ONBOARD SERIAL PORT 1/2
Select an address and corresponding interrupt for the first and second
serial ports.
3. UART MODE SELECT
This item allows you to select UART mode.
4. RxD, TxD ACTIVE
This item allows you to determine the active of RxD, TxD.
PMB-732LF USER
Phoenix – Award CMOS Setup Utility
F6:Fail-Safe Defaults
'
S MANUAL
Chapter 4 Award BIOS Setup
SuperIO Device
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
[Hi, Lo]
[Enabled]
Half
IR-Rx2Tx2
[378/IRQ7]
[Standard]
3
[On]
F7:Optimized Defaults
Item Help
Menu Level ►
Page: 4-15
Advertisement
Table of Contents
