Multiple Users; Information Messages - Hughes 9202 User Manual

Multiple Users

Information Messages

When setting up contexts from the menu, these messages are possible:
MustDeact1st
Deact;TryAgn
NotPSAttachd
No TE Found
Activating..
When taking down contexts from the menu, these messages are possible:
Deactivating
NoCntxtActiv
When sending SMS messages from the menu, these are possible:
NotCSAttachd
Sending SMS
SMS Sent
SMS Failed
If in pointing mode, this message is possible on the LCD:
Insert SIM
If changing the Telephony settings, this message is possible on the LCD:
Multiple TEs can be connected to the 9202, e.g. via the wireless
LAN interface or if an external hub or switch is used. To use the
menu and keypad to control connections for all the TEs, press
the User button and the display will cycle through the IP
addresses of the connected TEs.
To activate a context for a particular TE, press the user button
until the correct IP address is displayed, and then press the
Accept button to enter the menu and control the PDP context.
The following table shows possible error and status messages
with explanations and suggested actions. Most of these
messages will self-clear after 15 seconds, or can be cleared
immediately by pressing any button on the front panel.
There is already a context up for this TE, deactivate it before setting
up a new one
UT is in the process of deactivating a context, try setting up the
context a short time later
UT is currently not PS attached, context setup is not possible
There is no TE currently connected/identified by the UT as available
for data traffic
The UT is now attempting to establish the requested context; this
message appears until the context is setup or an error is detected
The context is being deactivated; this message appears until the
context is deactivated or an error is detected
The TE for which context deactivation is being requested doesn't
have a context setup at this time
The UT is currently not CS attached, so it cannot send an SMS
message at this time
The UT is sending the requested SMS message
The UT has sent the requested SMS message
The UT failed to send the requested SMS message
There was no SIM detected; pointing can still continue, but once
complete, "No SIM" will appear permanently and only emergency
calls can be made (this message remains on for about 1 minute,
then self-clears)

Using the LCD and Keypad
3004149-0001 Revision C
19