Quick Start - Hughes 9202 User Manual

Quick start

Power on the unit by pressing the power button for at least 2
seconds.
Since the Hughes 9202 terminal is a portable device, you must
first obtain a GPS fix and point the terminal to the satellite
before setting up a data connection with the network.
You can use the LCD display to aid in pointing as described in
Using the LCD and Keypad on Page 11.
The top line gives the compass bearing and elevation angle of
the closest satellite.
Use the signal quality bar and numeric display on the lower
line to help point the UT to the satellite. While in pointing
mode, you may also activate the audio pointing aid by a long
press of the audio button on the right.
Once you have accurately pointed the unit to the satellite, exit
pointing by a long press of the Back button. The unit will now
attempt to register with the satellite network.
Once the unit has registered and is Circuit Switched (CS) and
Packet Switched (PS) Attached, you can create a data
connection from the menu by pressing the Accept button.

Using the Hughes 9202
5
3004149-0001 Revision C