Verizon FiOS-G1100 Quantum User Manual page 29

Enable the protected setup by moving the selector to On.
2.
Use one of the following methods:
3.
• If your wireless client device has a WPS button, press
the WPS button on your Gateway, then click the WPS
button on your wireless device (client) to start the WPS
registration process.
• If your client device has a WPS PIN, locate the PIN printed
on the client's label or in the client documentation.
Enter the PIN number in the Client WPS PIN field. The
Client WPS PIN field is located in the section B - PIN
Enrollment on the user interface.
Click Register.
• Alternatively, you can enter the Gateway's PIN
shown on this screen into the WPS user interface
of your device, if this PIN mode is supported by
your wireless device.
After pressing the WPS button on your Gateway, you have
4.
two minutes to press the WPS button on the client device
before the WPS session times out.
When the WPS button on your Gateway is pressed, the
Wireless light on the front of your Gateway begins flashing
white. The flashing continues until WPS pairing to the client
device completes successfully. At this time, the Wireless
light turns solid white.
verizon.com/fios |
02 / CONNECTING
YOUR GATEWAY
©
2014 Verizon. All Rights Reserved.
28