Micon Version Display; Lcd All Segment Blinking; Tuner Version; Dvd Test Mode - JVC DX-T7 Service Manual

9. Micon version display

TEMPORARY DISPLAY FOR MICON VERSION (5SEC)
After 5 seconds, return to previous display.
Each key press will toggle temporary display for the
following:
SYSCON VERSION DVD LSI (BE) VERSION)
DVD MECHA VERSION
DVD LSI (BE & FE) VERSION CAN ONLY BEEN
DISPLAY DURING
SYSTEM POWER ON IN DVD MODE
(WHEN DVD LSI P.ON)
IF THERE IS NO INFORMATION FEEDBACK,
SYS-CON WILL DISPLAY
"WAIT" BLINKING 0.5SEC ON & OFF
Press the [STANDBY], [ENTER] and [SET] keys on the
remote controller simultaneously in power on state .
FL indication
" xxxxxx-xxx "
Press the [STANDBY], [ENTER] and [SET] keys again on
the remote controller simultaneously in power on state .
FL indication
" xx xxxx "
Press the [STANDBY], [ENTER] and [SET] keys again on
the remote controller simultaneously in power on state .
FL indication
" xx xxxx "
Press the [STANDBY], [ENTER] and [SET] keys again on
the remote controller simultaneously in power on state .

10. LCD all segment blinking

LCD ALL SEGMENT BLINKING (0.5sec:ON/0.5sec:OFF)
Each key press will toggle this TEST mode ON/OFF.
Press the [STANDBY], [ENTER] and [+10] keys on the
remote controller simultaneously in power on state .
LCD all segment blinking.

11. Tuner version

SYSCON VERSION

12. DVD test mode

DVD LSI (BE) VERSION)
DVD MECHA VERSION
13. DVD initialize
Each Key pressed will display the current Sys-con
Tuner Version for 5 seconds and then changed back
to previous display.
U1 - 9KHz Display: " 0V USNE 9K "
U1 - 10KHz Display: " 0V USNE10K "
U2 - 9KHz Display: " 1V UW
U2 - 10KHz Display: " 1V UW
U3 - 9KHz Display: " 2V UX
U3 - 10KHz Display: " 2V UX
U4 - 9KHz Display: " 3V A
U5 - 9KHz Display: " 4V UY
U5 - 10KHz Display: " 4V UY
Press the [STANDBY], [ENTER] and [1] keys on the
remote controller simultaneously in power on state .
FL indication
" xx xxxx xx "
This check is completed.
Enters DVD-TEST mode.
DVD-TEST mode specification based on DVD-MODULE
specification. To exit DVD-TEST mode, AC OFF the system,
then AC ON again.
For Region Rewrite and DVD-AUDIO Device Key Writing,
refer to Region Rewrite and Device Key Writing section
below for exit procedure.
Insert a power cord in an outlet while pressing
the [STOP] and [DISC 5 EJECT] buttons on the
main unit simultaneously .
This unit is set to DVD test mode.
The details refer to "4.3.3 DVD test mode".
DVD module initialized.
Display will return to DVD Test Mode Area display
(" T xxy vw "). Press Power key to exit this TEST mode.
DVD test mode.
Press the [PAUSE] key
on the remote controller .
Wait for 10 seconds.
DVD initialize is completed.
9K "
10K "
9K "
10K "
9K "
9K "
10K "
Example)
0V USNE 9K
(No.MB368)1-57