Figure 11. Removing The Hard Disk Tray - HP Pavilion xz100 Troubleshooting And Self-Repair Manual

Screws,
M2.5x4mm (2)
Reassembly Notes
•
Insert the connector end of the drive through the opening in the tray, then lower the drive into
place.
•
Carefully slide the hard drive assembly into its compartment. Press firmly to make sure the
connector seats properly.
Important
If you are installing a new hard disk drive, install the factory software and operating system on the
drive before loading any additional software—see "Recovering the Factory Software Installation"
on page 37.
zt1100/xz100 and xt1000 Series
Troubleshooting and Self-Repair Guide

Figure 11. Removing the Hard Disk Tray

Screws,
M2.5x4mm (2)
Removing and Replacing Parts 41